[MPlayer-dev-eng] MPlayer on IRIX build

[Timo Kanera]

Hi,

On Wed, 13 Nov 2002 10:41:08 +0100
mplayer.development at graphicscave.com wrote:

> Things to note about mplayer on IRIX:
> - Video output on x11 seems to be not supported. The error "RGB32 not 
> supported on big-endian systems, please contact the developers. FATAL: Cannot 
> initialize video driver!" is shown

XShm output works (and allways did) just fine on this Octane..

> - Only video outputs on the screen that are left then are gl and gl2 (OpenGL 
> outputs) which are extremely slow.

currently lacking tram, so unable to test the gl and gl2 output. I'm
receiving an EMXI board in a few days, so currently this is my hope
to get scaled output with good performance. General performance (via
unscaled x11 output though) is very good I must admit. This 300MHz
R12000 plays even the largest 720xXYZ divx files I got here with no
framedrop. Without hardware colorspace conversion and stuff..

> - Audio output using "-ao sgi": everything initialises fine. "Start 
> playing..." appears. Then immediately *crash* with error: "MPlayer 
> interrupted by signal 11 in module: decode_audio. (the other available -ao 
> option "mpegpes" gives error "couldn't open/init audio device -> no sound"

Just saw this one, too. This is new though. Still worked just fine in the
0.90pre8 build I did a while ago.. 

greetings,
Timo

-- 
Timo Kanera . mailto:timo at kanera.de